2
Installing the Handle Retainers
Parts needed for this procedure:
2
Handle retainer
2
Hair pin cotter
Procedure
1.
While supporting the handle, remove the cable ties
securing the handle clamps to the side plates (
Figure 6
).
Figure 6
1.
Hair pin cotter
2.
Handle retainer
2.
Pivot the handle to the desired operating position,
insert a handle retainer over the handle clamp and into
the matching holes in the side plate (
Figure 6
).
3.
Secure the clamp in position with a hair pin cotter
(
Figure 6
).
4.
Repeat the procedure on the opposite side of the
handle.
5.
Adjust the handle height to the desired position; refer
to
Adjusting the Handle Height (page 18)
.
Note:
The machine is shipped with the handle
adjusted to the lowest position.
The machine is
traditionally operated with the handle telescoped out to
its maximum height.
3
Installing the Transport
Wheels
Parts needed for this procedure:
2
Transport wheels (Optional Transport Wheel Kit,
Model 04123)
Procedure
1.
Push the kick standdown with your foot
in the
center of the kick stand
and pull up on the lower
center machine handle until the kick stand has rotated
forward, over center (
Figure 7
).
Figure 7
1.
Kick stand
2.
Press the wheel locking clip toward the center of wheel
and slide the wheel onto the hex shaft (
Figure 8
).
Figure 8
1.
Locking clip
11
