Toro Greensmaster 3120, Operator'S Manual, Page: 13 / 48

5
Marking the Outer Grass
Baskets
No Parts Required
Procedure
To assist in aligning the machine for successive
cutting passes, do the following procedure to the No.
2 and No. 3 cutting unit baskets:
1. Measure in approximately 12.7 cm (5 inches)
from the outer edge of each basket.
2. Either place a strip of white tape or paint a line
onto each basket paralleling the outer edge of
each basket (
Figure 11 ).
g005115
Figure 11
1. Alignment strip 3. Cut grass on right
2. Approximately 12.7 cm (5
inches) 4. Keep focal spot 1.8 to 3
m (6 to 10 ft) ahead of the
machine.
6
Adding Rear Ballast and
Weight Kit
Parts needed for this procedure:
1
Rear Weight Kit (Part No. 100-6441)—purchase
separately
1
19.5 kg (43 lb) of calcium chloride (purchase
separately)
Procedure
This machine complies with the ANSI B71.4-2017.
Standard when you equip it with the Rear Weight
Kit (Part No. 100-6441) and add 19.5 kg (43 lb) of
calcium chloride ballast to the rear wheel.
Important:
If a puncture occurs in a tire with
calcium chloride, remove the machine from the
turf area as quickly as possible. To prevent
possible damage to the turf, immediately soak the
affected area with water.
13