Toro Greens Aerator, Service Manual

Page: 29 / 130

6. Reconnect electrical connections to engine:
A. Install harness wires (double green and yellow) to
starter motor solenoid side posts.
B. Connect harness alternator wire (white), fuel so-
lenoid wire (white/red) and magneto ground wire
(black) to engine leads (Fig. 6).
C. Install positive battery cable and fused harness
wire (red) to the starter motor solenoid stud (Fig. 6).
7. After engine installation, verify pulley alignment
across engine and hydraulic pump pulley faces with a
straight edge. If necessary, loosen two (2) set screws on
engine flywheel pulley and adjust location of pulley. Re-
tighten pulley set screws after alignment. Make sure
that shield (item 48) behind flywheel pulley is free to ro-
tate after pulley alignment.
8. Install hydraulic pump drive belt (see Pump Drive
Belt in the Service and Repairs section of Chapter 4 –
Hydraulic System).
9. Adjust hydraulic pump drive belt tension (see Opera-
tor’s Manual).
10.Install coring head drive belt to the engine PTO
pulley (see Coring Head Drive Belt in the Service and
Repairs section of Chapter 8 – Coring Head).
11. Install transaxle drive belt to the engine PTO pulley
(see Transaxle Drive Belt in the Service and Repairs
section of Chapter 7 – Drive Train).
12.Remove plug installed in fuel hose during disassem-
bly. Connect fuel hose to the fuel filter and secure with
hose clamp.
13.Connect spring (item 18) to clevis pin in shift plate
(Fig. 8).
14.Install exhaust system (see Exhaust System Instal-
lation in this section).
15.Check engine oil level (see Operator’s Manual).
16.Check all wires, control cables and hoses to make
sure that they are not contacted by rotating or moving
parts.
17.Connect positive (+) and then negative (–) battery
cables at the battery.
18.Install control cover to machine (Fig. 5).
19.Return coring head lock–up brackets to stored posi-
tion.
Engine
Greens Aerator Page 3 – 13 Engine