Toro Greenmaster Flex 04044, Operator'S Manual

Page: 9 / 40

g000483
Figure 6
1. Transmission coupling
4. Maneuver the machine frame forward until it
engages the cutting unit pivot arms
Figure 7 .
g032418
Figure 7
1. Telescoping coupler 3. Bolt
2. Cutting-unit hex shaft
5. Secure the machine frame to the cutting unit
pivot arms with the 2 bolts (3/8 x 3/4 inch)
(
Figure 7 ).
6. Move the kickstand to the S
TORAGE
position
by releasing the locking pin and allowing the
kickstand to rotate up.
7. Set the cutting-unit height of cut; refer to your
cutting unit
Operator’s Manual .
3
Installing the Handle
Retainers
Parts needed for this procedure:
2 Handle retainer
2 Hairpin cotter
Procedure
1. While supporting the handle, remove the cable
ties that secure the handle clamps to the side
plates (
Figure 8 ).
g017005
Figure 8
1. Hairpin cotter 2. Handle retainer
2. Pivot the handle to the desired operating position
and insert a handle retainer over the handle
clamp and into the matching holes in the side
plate (
Figure 8 ).
3. Secure the clamp in position with a hairpin cotter
(
Figure 8 ).
4. Repeat the procedure on the opposite side of
the handle.
5. Adjust the handle height to the desired position;
refer to
Adjusting the Handle Height (page 21) .
Note:
The machine is shipped with the handle
adjusted to the lowest position. The machine is
traditionally operated with the handle telescoped
out to its maximum height.
9