Figure 67
1.
Switch screws
3.
Nut and bolt
2.
Cam
9. After the cam is adjusted, the lever switch needs to
be checked.
10. Check the gap between the control lever and switch
as shown in Figure 68. The gap needs to be an 1/8
inch (3mm) with the right motion control lever in
the neutral, unlocked position.
11. If needed, loosen the screws holding the switch and
adjust the switch (Figure 67 and Figure 68).
Figure 68
1.
Switch
3.
Right motion control lever
in the neutral unlocked
position
2.
1/8 inch (3mm)
12. Tighten the switch screws.
Adjusting the Neutral Postion for the
Motion Control Levers
Important:
Ensure the tracking of the mower is
correct after adjusting the motion control levers.
Adjusting the tracking and aligning the motion
control levers front to back is the same procedure
(Figure 69).
Note:
Adjust the horizontal alignment before the front
to back alignment.
If the motion control levers do not align front to back,
or the right side control lever does not move easily into
the neutral lock position, adjustment is required.
1. After the horizontal alignment is finished, check the
front to back alignment (Figure 69).
48
Summary of Contents for GrandStand 74553
Page 61: ...Schematics Hydraulic Schematic Rev A 61...
Page 62: ...Electrical Schematic Rev A 62...
Page 63: ...Notes 63...
