Toro GrandStand 74553, Operator'S Manual

Page: 13 / 64

Figure 5
1. Safety interlock symbols
3. Hour meter
2. Battery light
Speed Control Lever
This machine has a variable speed control. This controls
how fast or slow the machine will travel.
Throttle Control
The throttle control is variable between Fast and Slow .
Choke
Use the choke to start a cold engine.
Blade Control Switch (PTO)
The blade control switch (PTO) is used to engage
the electric clutch to drive the mower blades with the
right side motion control lever in the center, un-locked
position. Pull the switch up to engage the blades and
release. To disengage the blades, push the blade control
switch (PTO) down or move or release the right side
motion control lever into the neutral lock position.
Ignition Switch
This switch is used to start the mower engine and has
three positions:
Off, Run and Start .
Motion Control Levers
The motion control levers are used to drive the machine
forward, reverse, and turn either direction.
Fuel Shut-off Valve
Close the fuel shut-off valve (on the right side of the
engine) when transporting or storing the mower.
Attachments/Accessories
A selection of Toro approved attachments and
accessories are available for use with the machine to
enhance and expand its capabilities. Contact your
Authorized Service Dealer or Distributor or go to
www.Toro.com for a list of all approved attachments
and accessories.
Specifications
Note:
Specifications and design are subject to change
without notice.
60 inch mowers:
Width with deflector down 75.67 inches (192.2 cm)
Length with platform down 74 inches (188 cm)
Length with platform up 58 inches (147.3 cm)
Height
48 inches (121.9 cm)
Weight with 26hp engine 925 (419.5 kg)
13