Lubrication
Grease with No. 2 general purpose lithium base or
molybdenum base grease.
Lubricate the traction rollers with a dry lubricant
(PTFE).
How to Grease
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. Clean the grease fittings with a rag. Make sure to
scrape any paint off the front of the fitting(s).
4. Connect a grease gun to the fitting. Pump grease
into the fittings until grease begins to ooze out of
the bearings.
5. Wipe up any excess grease.
Lubricating the Machine
Service Interval:
Every 50 hours—Grease the lift
linkage (more often in dirty or dusty
conditions).
Every 50 hours—Lubricate the speed
control linkage rollers (more often in
dirty or dusty conditions).
Every 200 hours—Grease the mower
deck spindles (more often in dirty or
dusty conditions).
Every 800 hours/Yearly (whichever
comes first)—Grease the front wheel
bearings (more often in dirty or dusty
conditions).
Every 800 hours/Yearly (whichever
comes first)—Grease the front caster
pivots (more often in dirty or dusty
conditions).
Use the following graphics for locating the grease points.
Figure 36
g013641
Figure 37
G013642
Figure 38
Lubricate the speed control linkage rollers with a dry
PTFE (Polytetrafluoroethylene) lubricant.
30
Summary of Contents for GrandStand 74553
Page 61: ...Schematics Hydraulic Schematic Rev A 61...
Page 62: ...Electrical Schematic Rev A 62...
Page 63: ...Notes 63...
