Adjusting the Anti-Scalp
Rollers (60 inch Mower Decks
Only)
Whenever you change the height-of-cut, it is recommended
to adjust the height of the anti-scalp rollers.
1.
Disengage the blade control switch (PTO), move the
motion control levers to the neutral locked position
and set the parking brake.
2.
Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3.
Remove the nut and bolt position the anti-scalp rollers
and install the nut and bolt. Ensure the spacers and
bushings are installed as shown.
g018324
Figure 29
1.
Bushing
4.
Bolt
2.
Anti-scalp roller
5.
Nut
3.
Spacer
Adjusting the Flow Baffle
The mower discharge flow can be adjusted for different types
of mowing conditions. Position the cam lock and baffle to
give the best quality of cut.
1.
Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
2.
Stop the engine, remove the key, and wait for all moving
parts to stop before leaving the operating position.
3.
To adjust the baffle, loosen the nut (Figure 30).
4.
Adjust the baffle and nut in the slot to the desired
discharge flow and tighten the nut.
g012676
1 2
Figure 30
1.
Slot
2.
Nut
Positioning the Flow Baffle
The following figures are only recommendations for use.
Adjustments will vary by grass type, moisture content, and
height of grass.
Note:
If the engine power draws down and the mower
ground speed is the same, open up the baffle.
Position A
This is the full rear position (see Figure 31). The suggested
use for this position is a follows.
•
Use for short, light grass mowing conditions.
•
Use in dry conditions.
•
For smaller grass clippings.
•
Propels grass clippings farther away from the mower.
G012677
Figure 31
Position B
Use this position when bagging (Figure 32).
25
