Figure 26
1.
Lower tube
4.
Locknut (#10)
2.
Upper tube
5.
Bolt (#10 x 3/4 inches)
3.
Flat washer (7/32 inch)
15.
Install the lower tube onto the blower housing and
secure it with the latches.
16.
Install the bags onto the bagger.
9
Installing the Belt Cover
Parts needed for this procedure:
1
Belt cover (from the Blower and Drive Kit)
Procedure
1.
Lower the mower deck to the lowest height-of-cut
position.
2.
Install the new belt cover so the notches on both sides
go over the belt-cover supports and secure the latch
(
).
Figure 27
1.
Belt cover
5.
Latch
2.
Blower assembly
6.
Belt-cover notch
3.
Pulley assembly
7.
Belt-cover support
4.
Belt-cover bracket
10
Installing the Weights
Parts needed for this procedure:
2
Caster weight
2
U-bolt
4
Nut (1/2 inch)
4
Lock washer (1/2 inch)
2
Plate
2
Top weight (for 60 inch mower decks only)
2
Bolt, 1/2 x 2–1/2 inch- for top weights
Procedure
To comply with ANSI/OPEI B71.4-2012 Standard, add
weights to the machine.
CAUTION
The bagger adds a lot of weight to the rear of the
machine and may cause an unstable condition that
could result in a loss of control.
1.
Place caster weights on the front casters.
15
