Toro 78281, Operator'S Manual

Page: 10 / 20

10
2. Raise attachment lift, turn Dial-a-Height knob
counterclockwise, all the way, and lower the attachment
lift lever to the mounting position; refer to tractor
Operator’s Manual.
3. Remove mower drive belt from engine pulley.
4. Remove hairpin cotter, washer and link pin from carrier
lift arm and remove from attachment lift (Fig. 16).
5. Remove hairpin cotter and washer from front adjustable
link(s) and remove from front lift arm (Fig. 16).
6. Remove hairpin cotters and washers from carrier lift
arms (Fig. 16).
7. Slide deck right, off carrier lift arms (Fig. 16).
1
1
6
7
4
m–3644
2
3
3
2
5
8
Figure 16
1. Link pin
2. Washer 1/2 in.
3. Hair pin cotter–small
4. Attachment lift
5. Carrier lift arm
6. Washer 3/4 in.
7. Hair pin cotter–large
8. Front adjustable link
8. Raise attachment lift all the way to the latched position.
Turn the front wheels, as necessary, and slide mower
out to the the right side.
Note: Save all hardware, washers and hairpin cotters for
use when installing deck.
Operation
Note: Determine the left and right sides of the machine
from the normal operating position.
Side Discharge
An uncovered discharge opening could allow the
lawn mower to throw objects in the operator’s or
bystander’s direction and result in serious injury.
Also, contact with the blade could occur.
•
Never remove the grass deflector from the
mower because the grass deflector routes
material down toward the turf. If the grass
deflector is ever damaged, replace it
immediately.
•
Never put your hands or feet under the mower.
•
Never try to clear discharge area or mower
blades unless you move the power take off
(PTO) to off and rotate the ignition key to off.
Also remove the key and pull the wire off the
spark plugs.
Warning
1. The mower has a hinged grass deflector that disperses
clippings to the side and down toward the turf.
Operating the Power Take Off
(PTO)
The power take off (PTO) engages and disengages power to
the electric clutch.
While the ignition key is in the run or lights position and
the power take off (PTO) is engaged or on, the PTO light,
in the Indicator Module, will be on. When this light is on it
is a reminder; the starter will not crank and to turn the off
PTO before getting off.
Engaging the Power Take Off (PTO)
1. Depress the brake and/or clutch pedal(s) to stop the
machine.
2. Pull the power take off (PTO) to the on position
(Fig. 17).