engine with oil below the low mark because the engine
may be damaged.
1.
Park the machine on a level surface, disengage the
blade control switch, stop the engine, engage parking
brake, and remove the key.
2.
Make sure the engine is stopped, level, and is cool so
the oil has had time to drain into the sump.
3.
To keep dirt, grass clippings, etc., out of the engine,
clean the area around the oil fill cap/dipstick before
removing it.
4.
Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position (Figure 44).
G008792
1
2
5
6
7
3
9
10
4
8
Figure 44
Changing the Engine Oil
Service Interval:
After the first 8 hours—Change the engine
oil.
Every 100 hours—Change the engine oil (more often
in dusty, dirty conditions).
Note:
Dispose of the used oil at a recycling center.
1.
Park the machine so that the drain side is slightly
lower than the opposite side to ensure the oil drains
completely.
2.
Disengage the PTO, move the motion control levers to
the neutral locked position and set the parking brake.
3.
Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position (Figure 45).
G012153
1
2
3
4
5
6
Figure 45
4.
Slowly pour approximately 80% of the specified oil
into the filler tube and slowly add the additional oil to
bring it to the
Full
mark (Figure 46).
35
Summary of Contents for 74920 TITAN ZX4820
