Adjusting the Clutch Pedal
Service Interval:
Every 200 hours
Note:
You can adjust the clutch pedal cable at the bell
housing or at the clutch pedal pivot. The front hood can
be removed to ease the access to pedal pivot.
1. Loosen the jam nuts securing the clutch cable to the
bracket on the bell housing (Figure 64).
Figure 64
1.
Clutch cable
3.
Return spring
2.
Jam nuts
4.
Ball joint
Note:
You may remove and rotate the ball joint, if
additional adjustment is required.
2. Disconnect the return spring from the clutch lever.
3. Adjust the jam nuts or ball joint until the back, rear
edge of the clutch pedal is 3.75 ± 0.12 inch (9.5
± 0.3 cm) from the top of the floor plate diamond
pattern, when an 4 lb (18 N) force is applied to the
pedal (Figure 65).
Figure 65
1.
Clutch pedal
2.
3.75 ± 0.12 inch (9.5 ± 0.3
cm)
Note:
Force is applied so the clutch release bearing
lightly contacts the pressure plate fingers.
4. Tighten the jam nuts after the adjustment has been
attained.
5. Recheck the 3.75 ± 0.12 inch (9.5 ± 0.3 cm)
dimension after the jam nuts have been tightened to
ensure proper adjustment. Readjust, if necessary.
6. Connect the return spring to the clutch lever.
Important:
Ensure that the rod end is
positioned squarely on the ball, not twisted, and
remains parallel to the clutch pedal after the jam
nut is tightened (Figure 66).
Figure 66
1.
Clutch cable rod end
3.
Rod end jam nut
2.
Clutch pedal
4.
Parallel
Note:
The clutch free play should never be less
than 0.75 inch (19 mm).
Converting the Speedometer
You can convert the speedometer from MPH to KPH
or KPH to MPH.
1. Position the vehicle on a level surface, stop the
engine, engage the parking brake, and remove the
key from the ignition switch.
2. Remove the hood. Refer to Removing the Hood in
the Pre-maintenance Procedures.
3. Locate the two loose wires next to the speedometer.
4. Remove the connector plug from the harness wire
and connect the wires together.
The speedometer will switch to KPM or MPH.
5. Install the hood.
47
Summary of Contents for 7354
