Heavy Duty Operation
Important:
If the vehicle is subjected to any of the conditions listed below, maintenance should be
performed twice as frequently:
•
Desert operation
•
Cold climate operation below 32 degrees F (0 degrees C)
•
Trailer towing
•
Frequent operation on dusty roads
•
Construction work
•
After extended operation in mud, sand, water, or similar dirty conditions, have your brakes inspected and cleaned
as soon as possible. This will prevent any abrasive material from causing excessive wear.
Premaintenance
Procedures
Removing the Full Bed
1. On each side of the machine, remove the flange
head bolt and flange nut securing the bed mounting
bracket to the frame bracket (Figure 28).
Figure 28
1.
Bed mounting bracket
2. Remove the lynch pins and clevis pins securing the
pivot brackets to the frame channels (Figure 29).
Figure 29
1.
Left rear corner of bed
4.
Clevis pin
2.
Vehicle frame channel
5.
Lynch pin
3.
Pivot plate
3. Lift the bed off of the vehicle.
CAUTION
The full bed weighs approximately 325 lb (147.5
kg), so do not try to install or remove it by
yourself. Use an overhead hoist or get the help
of two or three other people.
Installing the Full Bed
Note:
If the bed sides will be installed on the flat bed,
it is easier to install them before installing the bed on
the vehicle.
CAUTION
The full bed weighs approximately 325 lb (147.5
kg), so do not try to install or remove it by yourself.
Use an overhead hoist or get the help of two or
three other people.
32
Summary of Contents for 7354
