•
If the oil level is below the threads in the oil-level
port, add oil as follows:
A.
Remove the filler bolt and washer from the
filler port on the top of the reduction case
(Figure 64).
B.
Slowly add the specified oil into the fill port
until the oil level is level with the threads at
the bottom of the oil-level port.
C.
Install the filler bolt and the washer to the
filler port of the reduction case, and tighten
the filler bolt (Figure 64).
•
If the oil level is too high, allow the oil to flow out
until it is flush with the threads at the bottom of
the oil-level port.
5.
When the oil is level is flush with the threads at the
bottom of the oil-level port, install the oil-level-check
bolt and the washer to the port and tighten the
oil-level-check bolt (Figure 64).
6.
Install the divider plate; refer to Installing the Divider
Plate (page 28).
Changing the Reduction-case Oil
Service Interval:
After the first 20 hours—Change the
reduction-case oil
(Models 68013 and
68014 only).
Every 100 hours/Every 6 months (whichever comes
first)—Change the reduction-case oil
(Models 68013
and 68014 only).
1.
Remove the engine; refer to Removing the Engine
(page 34).
2.
Drain the fuel tank; refer to Draining the Fuel Tank
(page 36).
3.
Remove the filler bolt and washer from the filler port
on the top of the reduction case (Figure 65).
4
G020127
1
2
3
5
2
6
Figure 65
1.
Oil-level-check
bolt
3.
Oil-level port
5.
Filler port
2.
Washer
4.
Pulley
6.
Filler bolt
4.
Remove the oil-level-check bolt and washer from the
oil-level port in the side of the reduction case (Figure
65).
5.
Align a drain pan to the hinge of the engine deck
(Figure 66).
G020128
Figure 66
6.
Rotate the engine on the hinge side of the engine deck,
and drain the oil from the reduction case (Figure 66).
7.
Carefully lower the engine and engine deck.
8.
Slowly add the specified oil into the fill port until the
oil level is level with the threads at the bottom of the
oil-level port (Figure 64).
9.
Install the oil-level-check bolt and washer to the
oil-level port of the reduction case, and tighten the
oil-level-check bolt (Figure 65).
10.
Install the filler bolt and washer to the filler port of the
reduction case, and tighten the filler bolt (Figure 65).
37
Summary of Contents for 68013
Page 47: ...Notes 47 ...
