Toro 60213, Operator'S Manual

Page: 46 / 52

g020015
Figure 70
1. Engine pulley 4. Idler shaft
2. Idler pulley 5. Locknut
3. Straightedge 6. Set screw
Note:
Both pulleys must be aligned flush with
the straightedge.
6. If the pulleys are not aligned do the following:
A. Move the clutch lever to the O
FF
position.
B. Loosen the locknuts and setscrews that
secure the idler pulley to the idler shaft
(
Figure 70 ).
C. Using a soft-face mallet, tap the idler pulley
forward or backward along the idler shaft
until the engine pulley and idler pulley are
aligned to the straight edge (
Figure 70 ).
D. Tighten the set screws and locknuts that
secure the idler pulley to the idler shaft
(
Figure 70 ).
7. Install the divider plate; refer to Installing the
Divider Plate (page 28) .
Paddle Maintenance
Adjusting the Paddles
Important:
Complete the Preparing the Machine
for Maintenance (page 28) before adjusting any
of the paddles.
Note:
Over time, you may need to adjust the mixer
paddles to account for wear.
Aligning the Circumferential-Drum
Wipers
1. Rotate a paddle from the left row of paddles
around the drum and locate at the interior of the
drum the smallest distance between the drum
and the wiper of the paddle (
Figure 71 ).
2. Mark the inside of the inside of the drum at the
location that you determined in step
1 .
g029066
Figure 71
3. Align the wiper of a paddle to the mark.
4. Loosen the carriage bolts and flanged locknuts
that secure the paddle blade and wiper to the
paddle (
Figure 72 ).
46