Product Overview
Controls
Flow Control Valve for Floor
Model 44701 Only
A hydraulic flow control valve controls the speed of the
conveyor belt.
The highest speed setting is 10 and is typical for most
applications found on the Color-Coded Operation System
decals. Use lower settings for very light applications.
Figure 21
1.
Floor control valve
Flow Control Valve for Options
Model 44701 Only
Figure 22
1.
Option control valve
A hydraulic flow control valve controls the speed of the
option (Twin Spinner). The spinner icon indicates the speed
percentage for the wireless controller only—for standard
hydraulics, place the control in the appropriate color area,
starting at the dotted line and adjust speeds within the color
zone as required.
On/Off Pendant
Model 44701 Only
Use the two switches on the On/Off pendant to run the
conveyor belt or the option (
). Keep the On/Off
pendant within reach of the operator.
Figure 23
1.
On/off pendant
E-Stop Button
Model 44751 Only
When finished working with the machine, always press the
E-S
TOP
button (
) to disable the electrical system.
When beginning work with the machine you must pull the
E-S
TOP
button back out before turning on the handheld
remote.
Figure 24
1.
E-S
TOP
Button
Diagnostic LED Function
After pulling up the E-S
TOP
button, the diagnostic LED
) will illuminate and remain on for 5 seconds, turn
off for 5 seconds, and then will begin flashing at 3 Hz (3
flashes a second) until you turn the handheld remote on. If
the light turns on for 5 seconds and then starts blinking at 10
Hz (with or without a 5 second pause), there is a fault with
the machine; refer to
Checking Fault Codes (EH Models
.
Note:
If you had the handheld remote on when you pulled
up the E-S
TOP
button, the light will not flash at 3 Hz (3
flashes per second) after turning off for 5 seconds.
16
