Toro 44701, Operator'S Manual

Page: 12 / 44

Figure 8
1. Socket bracket
2. Route and secure the electrical wiring from the battery
to the electrical plug bracket (
Figure 9 ).
Figure 9
1. White wire (brass) 3. No wire (brass)
2. No wire silver (silver) 4. Black wire (brass)
3. Feed the wiring through the socket bracket and install
the black rubber grommet over the wiring (
Figure 9 ).
4. Bolt the socket to the socket bracket using the bolts
(1/4 inch).
5. Connect the red wire (power) to the positive post on
the battery, then connect the black wire (ground) to the
negative post on the battery.
3
Installing the Hopper
Extension Kit
Parts needed for this procedure:
1 Hopper extension-front
1 Hopper extension-rear
9 Bolt
9 Flange nut
Procedure
1. Remove the hopper extensions from the box and
identify the front and the rear (
Figure 10 and Figure 11 ).
Figure 10
1. Front hopper extension (showing hole orientation)
Figure 11
1. Rear hopper extension (showing hole orientation)
2. Using the hardware provided, attach the hopper
extensions to the hopper. Place the nuts on the outside
of the hopper.
12