23
Pressure Gauge
The pressure gauge is located to the right of the tank
(Fig. 27). This gauge shows the pressure of the fluid in the
system in psi and bar.
Pump
The pump is located near the rear of the vehicle (Fig. 28).
2
1
Figure 28
1.
Pump
2.
Grease fitting
Tank Drain Handle
The tank drain handle is located on top of the tank
(Fig. 29). Pull the handle up to drain the tank.
1
Figure 29
1.
Tank drain handle
Important
Pull the knob gently out until it stops. Do
not pull too hard or you may damage the knob.
Tank Cover
The tank cover is located in the center of the top of the
tank (Fig. 30). To open it, turn off the engine and set the
parking brake, then turn the front half of the cover to the
left and swing it open. You can remove the strainer inside
for cleaning. To seal the tank, replace the strainer if
removed, close the cover, and rotate the front half toward
the right.
2
1
Figure 30
1.
Tank cover
2.
Anti-siphon fill receptacle
Anti-siphon Fill Receptacle
The anti-siphon fill receptacle, in front of the tank cover,
is a hose receptacle with a threaded fitting and a 90 degree
barbed fitting which you can direct toward the tank
opening (Fig. 30). This receptacle allows you to connect a
water hose and fill the tank without contaminating the
hose and water supply with the chemicals in the tank.
Important
Do not allow the hose receptacle to contact
tank fluids. Do not lengthen the hose to allow contact with
the tank fluids.
