![background image](http://html1.mh-extra.com/html/toro/39696/39696_operators-manual_1133856014.webp)
Important:
Do not use fuel additives
containing methanol or ethanol.
Add the correct amount of gas
stabilizer/conditioner to the gas.
Note:
A fuel stabilizer/conditioner is most
effective when mixed with fresh gasoline. To
minimize the chance of varnish deposits in the fuel
system, use fuel stabilizer at all times.
Filling the Fuel Tank
1. Shut the engine off and set the parking brake.
2. Clean around fuel tank cap and remove the cap.
Add unleaded regular gasoline to fuel tank, until the
level is 1/4 to 1/2 inch (6 to 13 mm) below the
bottom of the filler neck. This space in the tank
allows gasoline to expand. Do not fill the fuel tank
completely full.
3. Install fuel tank cap securely. Wipe up any gasoline
that may have spilled.
Think Safety First
Carefully read all the safety instructions and decals in
the safety section. Knowing this information could
help you or any bystanders avoid injury.
The use of protective equipment for eyes, hearing, feet
and head is recommended.
This machine produces sound levels in excess
of 85 dBA at the operator’s ear and can cause
hearing loss through extended periods of
exposure.
Wear hearing protection when operating this
machine.
Figure 5
1.
Warning—wear hearing protection.
Operating the Parking Brake
Stop on level ground, disengage drives, engage parking
brake, shut off engine and remove key. Always set the
parking brake when you stop the machine or leave it
unattended.
Children or bystanders may be injured if they
move or attempt to operate the machine while
it is unattended.
Always remove the ignition key and set the
parking brake when leaving the machine
unattended, even if just for a few minutes.
Setting the Parking Brake
1. Pull the upper control bar rearward and hold it in
this position (Figure 6).
2. Lift the parking brake lock up and gradually release
the upper control bar. The brake lock should stay in
the set (locked) position (Figure 6).
Releasing the Parking Brake
1. Pull rearward on the upper control bar. Lower the
parking brake lock to the released position.
2. Gradually release the upper control bar.
Figure 6
1.
Upper control bar
3.
Fixed bar
2.
Parking brake lever-set
position
Starting and Stopping the
Engine
Starting the Engine
1. Connect the wires to the spark plugs.
2. Open the fuel valve.
3. Disengage the blade control (PTO) lever and move
the shift lever to the
neutral
position.
4. Set the parking brakes.
5. Turn the ignition key to the
run
position (Figure 7).
14
Summary of Contents for 39696
Page 6: ...Slope Chart 6...