3. Remove the lower bolts (3/8 x 1 inch) and flange
nuts securing handle to rear frame (Figure 14).
4. Pivot the handle to the desired operating position
and install the lower flange bolts (3/8 x 1 inch)and
flange nuts into the mounting holes. Tighten all
flange bolts.
Figure 14
1.
Upper handle
6.
Lower mounting holes
2.
Rear frame
7.
Low position
3.
Flange bolt (3/8 x 1 inch)
8.
Middle position
4.
Lock nut (3/8 inch)
9.
High position
5.
Upper mounting hole
5. Adjust the control rod length by rotating the control
rod in the rod fitting (Figure 13).
6. Install a hairpin cotter between the drive levers and
neutral locks and into the clevis pins (Figure 13).
Note:
Make sure the clevis pins are inserted into
the neutral locks.
7. Check the parking brake adjustment. Refer to
Checking the Brakes in Brake Maintenance.
18
Summary of Contents for 38682
Page 6: ...Slope Chart 6...
