Toro 31698, Operator'S Manual, Page: 35 / 100

g031661
Figure 28
1. Tensioning cap 4. Top axle-mounting hole
2. Spacers (6) 5. Caster wheel
3. Shims (2 top and 2 bottom)
g031663
Figure 29
1. Left, front, outside caster
arm 3. Right, front, inside caster
arm
2. Left, front, inside caster
arm 4. Right, front, outside caster
arm
6. If the inside edge is still too high, remove an
additional shim from the bottom of the front,
inside caster arm of the wing cutting unit and 1
shim from the front, outside caster arm of the
wing cutting unit (
Figure 28 and Figure 29 ).
7. If the inside edge of the wing cutting unit is
too low relative to the outside edge of the front
cutting unit, add 1 shim (1/8 inch) to the bottom
of the front, inside caster arm on the wing cutting
unit (
Figure 28 and Figure 29 ).
Note:
Check the measurement between the
outside edges of both wing cutting units and the
inside edge of the wing cutting unit to the outside
edge of the front cutting unit again.
8. If the inside edge is still too low, add an additional
shim to the bottom of front, inside caster arm
of the wing cutting unit and 1 shim to the front,
outside caster arm of the wing cutting unit.
9. Once the mowing height matches at the edges
of the front and wing cutting units, verify that the
cutting unit unit pitch is still 7.6 mm (0.3 inch).
Adjusting the Mirrors
For Machines with a Cab
Rear-View Mirror
While sitting in the seat, adjust the rear-view mirror
to attain the best view out of the rear window. Pull
the lever rearward to tilt the mirror to reduce the
brightness and glare of light (
Figure 30 ).
g008870
Figure 30
1. Side-view mirrors 3. Lever
2. Rear-view mirror
Side-View Mirrors
While sitting in the seat, have another person adjust
the side-view mirrors to attain the best view around
the side of the machine (
Figure 30 ).
Aiming the Headlights
Model 31698 Only
1. Loosen the mounting nuts and position each
headlight so that it points straight ahead.
Note:
Tighten the mounting nut just enough to
hold the headlight in position.
2. Place a flat piece of sheet metal over the face of
the headlight.
3. Mount a magnetic protractor onto the plate.
35