Toro 30873, Operator'S Manual

Page: 27 / 72

Lowering the Roll Bar
Important:
Lower the roll bar only when
necessary.
Important:
Ensure that the seat is secured with
the seat latch.
g201853
Figure 19
Raising the Roll Bar
g201854
Figure 20
Adjusting the Height of Cut
Important:
The cutting units often cut
approximately 6 mm (1/4 inch) lower than a reel
cutting unit with the same bench setting. It
may be necessary to set the cutting-unit bench
measurement at 6 mm (1/4 inch) above that of reel
cutting units cutting in the same area.
Important:
Access to the rear cutting units is
greatly improved by removing the cutting unit
from the machine.
1. Park the machine on a level surface, engage
the parking brake, lower the cutting unit to the
ground, shut off the engine, and remove the key.
2. Loosen the bolt securing each height-of-cut
bracket to the height-of-cut plate (front and each
side) as shown in
Figure 21 .
3. Beginning with front adjustment, remove the
bolt.
g011344
Figure 21
1. Height-of-cut bracket 3. Spacer
2. Height-of-cut plate
4. While supporting the chamber, remove the
spacer (
Figure 21 ).
5. Move the chamber to the desired height of
cut and install a spacer into the designated
height-of-cut hole and slot (
Figure 22 ).
g201855
Figure 22
6. Position the tapped plate in-line with the spacer.
27