Figure 3
1.
Attachment frame
3.
Right arm
2.
Stop
2
Mounting the Castor Wheels
No Parts Required
Procedure
The castor wheel assemblies are installed upside down
on the debris blower for shipping
1. Remove the tensioning caps from the spindle shafts
and slide off the castor wheel, spacers, and thrust
washers (Figure 4).
2. Slide the spacers onto the castor spindle to get the
desired height. Slide a thrust washer onto the spindle
and push the castor spindle through the frame.
Install another thrust washer and the remaining
spacers onto the spindle and install the tensioning
cap to secure the assembly (Figure 4).
Important:
The thrust washers-not the
spacers-must contact the top and bottom of the
blower frame.
3. Ensure that both castor wheels are set at the same
height.
Figure 4
1.
Tensioning cap
3.
Spacers
2.
Thrust washers
3
Lowering the Stand
No Parts Required
Procedure
1. Remove the snapper pin securing the stand to the
tube on the blower frame (Figure 5).
Figure 5
1.
Snapper pin
2.
Stand tube
8
