Toro 30667, Installation Instructions Manual, Page: 10 / 20

2. Insert the cable tie through the slots in the
column mount bracket so that the ends are
outward, but do not tie them.
3. Install the steering-column bracket onto the
steering column with the mounting bracket, 2
carriage bolts, and 2 flange nuts (
Figure 14 ).
Important:
Ensure that the top of the
steering-column bracket is 21 mm (0.83 inch)
below the top of the steering column.
Important:
Torque the fasteners to 19 to 24
N∙m (14 to 18 ft-lb). Do not overtighten the
carriage bolts; otherwise, you may deform
the steering-column bracket.
8
Installing the Brake-Sensor
Bracket
Parts needed for this procedure:
1 Carriage bolt (#10 x 5/8 inch)
1 Locknut (#10)
1 Sensor plate
2 Flange nut (1/4 inch)
1 Brake-sensor bracket
2
Bolts (1/4 x 3/4 inch)
2 Slotted screw (#6 x 1 inch)
4 Washer (#6)
1 Brake sensor
2 Locknut (#6)
Procedure
Note:
This procedure is only for machines with
halogen headlights. Use Figure 15 to determine if you
have halogen headlights.
g312027
Figure 15
1. Halogen headlight 2. LED headlight
1. Disassemble the proximity-sensor assembly on
the brake-pedal lever (
Figure 16 ) and set aside
all the parts except the proximity sensor.
g029761
Figure 16
1. Forward footrest 4. Proximity sensor
2. Carriage bolt (#10 x 5/8
inch) 5. Brake-pedal lever
3. Brake-sensor plate 6. Locknut (#10)
2. Assemble the proximity-sensor assembly to the
brake lever using the carriage bolt (#10 x 5/8
inch), brake-sensor plate, proximity sensor, and
locknut (#10) as shown in
Figure 16 .
Note:
Ensure that you do not overtighten the
bolts. Overtightening the bolts will damage the
sensor.
3. Locate the brake-sensor bracket mounting holes
on the front footrest and loosely install the
brake-sensor bracket to the front footrest using 2
bolts (1/4 x 3/4 inch) and 2 flange nuts (1/4 inch).
Note:
You will need to move the brake-sensor
bracket up or down to align the brake sensor to
the brake-sensor plate (
Figure 17 ).
10