13
Assembly
Note: Determine the left and right sides of the machine
from the normal operating position.
Loose Parts
Note: Use the chart below to verify all parts have been shipped.
DESCRIPTION
QTY.
USE
Seat
Bolt, 5/16 x 1 in.
Lock nut, 5/16 in.
R-clamp
1
4
4
1
Installing the seat
Spacer
Steering wheel
Roll pin, 1/4 x 2-1/2 in.
1
1
1
Installing the steering wheel
Weight
Bolt, 1/2 x 3-1/2 in.
Washer, 1/2 in.
Nut, 1/2 in.
2
4
4
4
Installing the rear weight
Carriage bolt, 1/4 x 3/4 in.
Wing nut, 1/4 in.
2
2
Installing the battery cables
Operator’s Manual
Parts catalog
Registration card
1
1
1
Read before operating machine
Fill out and return to Toro
Installing the Seat
1. Position seat assembly onto seat plate aligning
mounting holes (Fig. 2).
2. Slide wire clamp over seat switch wire (Fig. 2).
3. Using left front hole, loosely secure wire clamp and
seat to seat base with capscrews and lock nuts (Fig. 2).
4. Mount seat to seat base with (3) remaining bolts and
lock nuts.
5. Route seat switch wire through the slot in seat plate
and plug connector onto seat switch (Fig. 2).
6. Tighten all lock nuts and check operation of seat.
7. Make sure wire harness is clear of lift arm and all
moving parts.
M–4264
1
2
3
4
Figure 2
1.
Seat plate
2.
R-clamp
3.
Seat switch wire
4.
Seat switch connector
