Toro 30460, Operator'S Manual

Page: 15 / 32

Figure 23
1. Hood plate 4. 19 mm (3/4 inch)
2. Upper tube 5. Edge of tube
3. Hood in the down position
7. Once the 3/4 inch (19 mm) measurement has been
achieved, mark the upper tube on the outside where
the rubber seal protrudes out. This is marked to ensure
the correct position for the upper tube when drilling
the holes and connecting the upper and lower tubes
(
Figure 24 ).
Note:
The rubber seal must protrude out from the
bagger hood.
Figure 24
1. Upper tube 3. Bagger hood
2. Rubber seal protruding out 4. Mark here against the
rubber seal
8. Install the middle and lower tube assembly into the
upper tube (
Figure 25 ).
Figure 25
1. Middle and lower tube 2. Upper tube
9. Slide the lower tube onto the blower assembly and latch
them together (
Figure 26 ).
Note:
There are two latches on the blower housing.
Figure 26
1. Blower assembly 3. Latch
2. Lower tube
10. Make sure the mower deck is in the lowest height-of-cut
position and the mark on the upper tube is still
positioned against the protruding rubber seal.
11. Using the 3 holes or indentations in the upper tube as a
template, drill 3 holes (7/32 inch diameter) where the
upper and middle tubes join together (
Figure 27 ).
15