Toro 30460, Operator'S Manual

Page: 16 / 32

Figure 27
1. Blower assembly 4. Upper tube
2. Lower tube 5. Bagger hood
3. Middle tube 6. Drill 7/32 inch diameter
holes here (use upper tube
as a template)
12. Remove the middle and lower tube assembly from the
blower and upper tube..
13. Remove the hardware and the middle tube from the
lower tube (
Figure 20 ).
14. Join the upper and middle tubes with 3 bolts (#10 x
3/4 inches), 3 flat washers (7/32 inch), and 3 locknuts
(#10) (
Figure 28 ).
Figure 28
1. Middle tube
4. Locknut (#10)
2. Upper tube 5. Bolt (#10 x 3/4 inches)
3. Flat washer (7/32 inch)
15. Install the lower tube into the middle tube and secure it
with 3 bolts (#10 x 3/4 inches), 3 flat washers (7/32
inch), and 3 locknuts (#10) (
Figure 20 ).
16. Install the lower tube onto the blower housing and
secure it with the latches.
17. Lift and lower the mower deck to verify that the end of
the tube does not come out of the bagger hood.
12
Installing the Belt Cover and
Bolt
Parts needed for this procedure:
Belt cover
1 Bolt (1/2 x 2-1/2 inches)
1 Nut (1/2 inch)
Procedure
1. Lower the mower deck to the lowest height-of-cut
position.
2. Install the new belt cover so the notches on both sides
go over the belt cover supports and secure the latch
(
Figure 29 ).
Figure 29
1. Knob 3. Mower deck
2. Belt cover
3. Lower the mower deck and install a bolt (1/2 x 2-1/2
inches) and nut (1/2 inch) into the 152 mm (6 inch)
height-of-cut hole (
Figure 30 ). This will prevent
damage to the double pulley when raising the mower
deck up.
16