17
3
Step
Parts needed for this step:
•
2 E–clips
Installing the Control Rods
1. For a starting point, make sure the rod fittings are
threaded approximately 2–1/2 inches (63 mm) onto the
control rods (Fig. 5).
2. Install the rod fittings into the and secure them with
E–rings (Fig. 5).
1
3
2
m–6601
4
Figure 5
1.
Control rod
2.
Rod fitting
3.
2–1/2 inch (63.5 mm) from
bottom
4.
E–ring
4
Step
Parts needed for this step:
•
1 Cotter pin
•
1 Washer
Installing the Speed Control
Rod
1. Install the swivel into the speed control crank and
secure it with a washer and cotter pin (Fig. 6).
Note: If necessary move the speed control lever until the
swivel will go into the speed control crank.
m–6602
1
2
3
4
5
3
6
Figure 6
1.
Speed control rod
2.
Swivel
3.
Nut
4.
Speed control crank
5.
Cotter pin
6.
Washer
Summary of Contents for 30436
Page 7: ...7 Slope Chart...
Page 8: ...8...
