![background image](http://html1.mh-extra.com/html/toro/30332/30332_operators-manual_1133846028.webp)
28
2. Lubricate the idler bracket pivots located in the back
of the machine (Fig. 29).
m–5389
Figure 30
Greasing the PTO Drive Belt Idler and
Deck Belt Idler
1. Stop the engine, set the parking brake, remove the key
and disconnect the spark plug wire(s) from the spark
plug(s).
2. Grease the idler pulley pivots (Fig. 31).
Note: You’ll have to remove the carrier covers to access
the grease fitting for the deck.
3. Grease the idler pulley pivots (Fig. 31).
M-5194
Figure 31
Cleaning the Cooling System
Service Interval/Specification
Before each use, check and clean engine cooling system.
Remove any build–up of grass, dirt or other debris from
the cylinder and cylinder head cooling fins, air intake
screen on flywheel end, and carburetor–governor levers
and linkage. This will help insure adequate cooling and
correct engine speed and will reduce the possibility of
overheating and mechanical damage to the engine.
Tire Pressure Service
Service Interval/Specification
Maintain the air pressure in the front and rear tires as
specified. Check the pressure at the valve stem after every
50 operating hours or monthly, whichever occurs first
(Fig. 32). Check the tires when they are cold to get the
most accurate pressure reading.
Rear Tire Pressure: 12–14 psi (83–97 kPa)
Castor Tire Pressure: 20–24 psi (138–165 kPa)
2
1
m–2147
Figure 32
1.
Rear Tire
2.
Castor tire
Fuse Service
Service Interval/Specification
The electrical system is protected by a fuse. It
requires no maintenance. If the fuse blows check
component or circuit for malfunction or short.
To replace fuse pull out on the fuse (Fig. 33) to
remove and push in to install it.
Fuse:
F1–10 amp, blade-type
Summary of Contents for 30332
