Toro 30200-70001, Operator'S Manual

Page: 21 / 32

21
Maintenance
✓
Initial break in at 10 hours
✓✓
Initial break in at 80 hours
Replace moving hoses
Replace safety switches
Flush the cooling system and replace fluid
Replace hydraulic oil
Maintenance Procedure Maintenance Interval & Service
Drain and clean fuel tank
Replace cutting unit gear box oil
Pack rear wheel bearings
Coat transmission bypass pins with grease
✓✓
Torque head, adjust valves and check engine RPM
Service air filter
Replace fuel filter
Check rear wheel toe-in and steering linkage
✓
Charge transmission filter
✓
Torque the wheel lug nuts
✓✓
Change the engine oil filter
Check electric clutch gap adjustment
✓
Check PTO belt tension
Inspect cooling system hoses
Check battery fluid level
Check battery cable connections
Lubricate all grease fittings
Lubricate brake cables
Check cutting unit gear box oil level
Clean under cutting unit belt covers
Check cutting unit drive belt adjustment
✓✓
Change engine oil
Service air filter
Every
400 hours
Every
200 hours
Every 100
hours
Every 50
hours
Minimum Recommended Maintenance Intervals
Annual Recommendations:
Items are recommended every 1000 hours or
two years, whichever occurs first.