Toro 29517, Operator'S Manual

Page: 33 / 60

Changing the Engine Oil
Service Interval: After the first 5 hours
Every 100 hours (more often under severe
conditions.)
Note:
Dispose of the used oil at a recycling center.
1. Park the machine so that the drain side is slightly
lower than the opposite side to assure the oil
drains completely.
2. Shut off the engine, engage the parking brake,
remove the key, and wait for all moving parts to
stop before leaving the operating position.
3. Change the engine oil as shown in Figure 36 .
Note:
Torque drain plug to 18 N∙m (13 ft-lb).
g249685
Figure 36
4. Slowly pour approximately 80% of the specified
oil into the filler tube, and slowly add the
additional oil to bring it to the
Full mark ( Figure
37 ).
g249684
Figure 37
5. Start the engine and drive to a flat area.
6. Check the engine-oil level.
7. Reset the engine-oil service reminder; refer to
Resetting the Engine-Oil Maintenance Reminder
(page 33)
.
Resetting the Engine-Oil
Maintenance Reminder
1. Prepare the machine for maintenance; refer to
Preparing for Maintenance (page 30) .
Note:
You must engage the parking brake to
reset the maintenance reminder.
2. Cycle the key switch between the
RUN
position
and the
OFF
position 4 times within 8 seconds.
The Service Engine screen displays and flashes
(
Figure 38 ).
g212117
Figure 38
Service Engine Screen
3. Press down the multi-function switch.
The engine-oil maintenance reminder resets to
100.0 (hours), exits the Service Engine screen,
and returns to the default screen.
33