Toro 29517, Operator'S Manual

Page: 31 / 60

Lubricating the Grease
Fittings
Note:
See the chart below for service intervals.
1. Shut off the engine, wait for all moving parts to
stop, and remove the key. Engage the parking
brake.
2. Lubricate the fittings with NLGI grade No. 2
multi-purpose grease.
Refer to the following chart for fitting locations
and lubrication schedule.
Lubrication Chart
Fitting
Locations
Initial
Pumps
Number of
Places
Service
Interval
1. Front Wheel
Caster Hubs 1 2 Yearly
2. Tine Shaft
Bearings 1 4 25 hours
3. Belt Idler
Pivot 1 1 Yearly
g230394
Figure 31
1. Front wheel caster hub 3. Belt idler pivot
2. Tine shaft bearings
Engine Maintenance
Servicing the Air Cleaner
Service Interval: Every 50 hours—Clean the foam
pre-cleaner (more frequently in
dusty conditions).
Every 200 hours—Replace the foam
pre-cleaner.
Every 300 hours—Replace the paper air filter
(more frequently in dusty conditions).
Important:
Do not operate the engine without the
air filter assembly; extreme engine damage may
occur.
1. Release the latches on the cover for the air
cleaner.
2. Remove the cover and clean it thoroughly
(
Figure 32 ).
Note:
Be careful to prevent dirt and debris from
falling into the base.
g023795
Figure 32
1. Air-filter base 4. Cover
2. Paper air filter 5. Latch on the air-cleaner
cover (2)
3. Foam pre-cleaner
3. Remove the foam pre-cleaner, wash it with a
mild detergent and water, and then blot it dry
(
Figure 32 ).
4. Remove and inspect the paper air filter ( Figure
32 ); discard it if it is excessively dirty.
Important:
Do not try to clean a paper filter.
31