Toro 22291, Operator'S Manual, Page: 7 / 28

2. Install the handle ends onto the mower housing
with 2 hex-head-flange bolts (5/16 x 1-1/2
inches) and 2 flange nuts (5/16 inch) as shown
in
Figure 3 .
3. Set the machine to the desired cutting height;
refer to
Adjusting the Cutting Height (page 12) .
4. Route the control cables between the deck and
the handle to protect the cables from being
damaged (
Figure 4 ).
g033534
Figure 4
1. Cable guard 3. Cable(s)
2. Handle
5. Stand in the operating position to determine the
handle height that is most comfortable for you
(
Figure 5 ).
g024166
Figure 5
1. Handle 4. Medium handle height
2. Handle bracket (2) 5. Lowest handle height
3. Highest handle height
6. Secure the handle onto the handle brackets at
your desired handle height with 2 carriage bolts
(5/16 x 1-1/2 inches) and 2 flange nuts (5/16
inch) as shown in
Figure 6 .
Important:
Ensure that the bolt heads are
on the inside of the handle and that the nuts
are on the outside of the handle.
g024342
Figure 6
1. Carriage bolt—5/16 x
1-1/2 inches (2) 3. Flange nut—5/16 inch (2)
2. Handle bracket (2)
7. Position the cable guard onto the handle with
the cable(s) inside the guard , and secure the
guard to the handle with the 2 carriage bolts
7