Toro 22291, Operator'S Manual, Page: 6 / 28

Setup
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure Description Qty. Use
Handle 1
Hex-head-flange bolt (5/16 x 1-1/2
inches)
2
Carriage bolt (5/16 x 1-1/2 inches) 2
1
Flange nut (5/16 inch) 4
Install the handle.
2
No parts required
–
Install the recoil-starter rope in the rope
guide.
3
No parts required
–
Fill the crankcase with oil.
4
No parts required
–
Adjust the self-propel drive.
5
No parts required
–
Assemble the grass bag.
Important:
Remove and discard the protective
plastic sheet that covers the engine and any other
plastic or wrapping on the machine.
Note:
Determine the left and right sides of the
machine from the normal operating position.
1
Installing the Handle
Parts needed for this procedure:
1 Handle
2 Hex-head-flange bolt (5/16 x 1-1/2 inches)
2 Carriage bolt (5/16 x 1-1/2 inches)
4 Flange nut (5/16 inch)
Procedure
1. Remove the cable guard from the handle ( Figure
3 ) by removing the 2 carriage bolts and 2
locknuts that hold the cable guard to the handle.
g024341
Figure 3
1. Cable guard 4. Flange nut—5/16 inch (2)
2. Locknut (2) 5. Hex-head-flange
bolt—5/16 x 1-1/2 inches
(2)
3. Carriage bolt—1/4 x 1-1/2
inches (2)
Note:
Save the guard, the carriage bolts, and
the locknuts so that you can install them onto
the handle later in this procedure.
6