17
3. Select the hole in the height-of-cut bracket
corresponding to the height-of-cut desired, and insert
the clevis pin (Fig. 11).
4. Secure the clevis pin with the hairpin cotter (Fig. 11).
1
m–3654
3
2
Figure 11
1.
Height-of-cut lever
2.
Clevis pin
3.
Hairpin cotter
5. Lower the height-of-cut lever onto the clevis pin.
Adjusting the Anti-Scalp
Rollers
Whenever you change the height-of-cut it is
recommended to adjust the height of the anti-scalp rollers.
1. Disengage the PTO and stop the engine. Move the
controllers to the neutral locked position and apply the
parking brake. Remove the key.
2. After adjusting the height-of-cut, remove the nut and
washer while holding the stud with a wrench (Fig. 12).
Note: Do not remove the wheel nut and washer (Fig. 12).
m–4167
1
2
3
4
5
Figure 12
1.
Gage wheel
2.
Stud
3.
Washer
4.
Nut
5.
Wheel nut and washer.
Do not remove.
3. Select a hole so that the gage wheel is positioned to
the nearest corresponding height-of-cut desired
(Fig. 12).
4. Install the stud nut and washer (Fig. 12).
5. Repeat the adjustment on the other gage wheels.
Positioning the Seat
The seat can move forward and backward. Position the
seat where you have the best control of the machine and
are most comfortable.
1. Raise the seat and loosen the adjustment knobs
(Fig. 13).
2. Move the seat to the desired position and tighten the
knobs.
m–5163
1
Figure 13
1.
Adjustment knobs
