Form No. 3421-332 Rev C
Universal Groomer Drive MVP Kit
Reelmaster
®
18-inch, 22-inch, or 27-inch Cutting Units with 5-inch
or 7-inch Reel
Model No. 133-0150
Model No. 133-0151
Installation Instructions
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
Description
Qty.
Use
1
No parts required
–
Prepare the machine.
2
No parts required
–
Gather the tools required for setup.
3
No parts required
–
Determine where on the cutting unit to
install the groomer.
Extended splined insert (right-hand
threads)
1
Extended splined insert (left-hand
threads)
1
4
Flange locknut (3/8 inch)—Model
133-0151 only
2
Prepare the cutting unit.
Weight bracket
1
Hex-socket, button-head bolt (3/8 x 3/4
inch)
2
Right (yellow) reel adapter
1
Left (green) reel adapter
1
5
Groomer drive box
1
Install the groomer drive box and weight.
Hex-socket-head bolt
2
Pivot hub
1
O-ring
1
Idler assembly
1
Bearing shield
2
Adjuster collar
1
Stub-shaft assembly
1
Flange nut (3/4 inch)
1
Flange locknut (3/8 inch)—Model
133-0150 only
2
6
Jam locknut (3/8 inch)—Model 133-0151
only
2
Install the idler assembly.
Left HOC bracket assembly
1
Right HOC bracket assembly
1
Adjuster pin
2
Cotter pin
2
7
Flange locknut (3/8 with 5/8 hex)
2
Install the HOC bracket assemblies and
the front roller.
8
Cap
1
Install the groomer drive cap (For
universal groomer assemblies with no
rear roller brush kit installed only).
© 2019—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the USA
All Rights Reserved
*3421-332* C
