Toro 112-9248, Installation Instructions

Page: 4 / 4

Note:
Make sure that the basket lips are
parallel with the reel blades all the way across
the reel blades.
11. Tighten the jam nuts.
3
Installing the Rear Carrier
Frame
Parts needed for this procedure:
2 Short pull-arm extension
Procedure
1. Slide back the sleeve on the ball-joint receiver
and remove the receiver from the ball stud
(
Figure 5 ).
g218561
Figure 5
1. Ball stud 3. Jam nut
2. Ball-joint receiver 4. Short pull-link extension
2. Loosen the jam nuts and remove the pull-arm
extension (
Figure 5 ). Remove the jam nuts from
the pull-arm extension.
3. Install the new shorter pull-arm extension with
the previously removed jam nuts (
Figure 5 ). Do
not tighten the jam nuts.
4. Adjust the pull arms until there is a 6 to 10 mm
(1/4 to 3/8 inch) clearance for 2006 and earlier
machines, or a 2 to 3 mm (1/16 to 1/8 inch)
clearance for 2007 and after machines, between
the lip of the basket and the reel blades.
Note:
Make sure that the basket lips are
parallel with the reel blades all the way across
the reel blades.
5. Tighten the jam nuts.
4