Note:
Make sure the basket lips are parallel
with the reel blades all the way across the reel
blades.
11.
Tighten the jam nuts.
2007 and Later Machines
1.
Slide back the sleeve on the ball-joint receiver
and remove the receiver from the ball stud
(
)
g218641
Figure 3
1.
Ball stud
7.
Bushing
2.
Ball-joint receiver
8.
Pull-link assembly
3.
Jam nut
9.
Spacer
4.
Pull-link extension
10.
Anti-scalp roller
5.
Locknut
11.
Roller shaft
6.
Flat washer
2.
Remove the locknuts and roller shafts securing
the anti-scalp rollers and the pull-link assemblies
to each carrier frame (
).
3.
Disassemble the pull-link assemblies (
).
4.
Thread a previously removed jam nut onto each
of the new longer pull-arm extensions and onto
the existing pull-link and bushing assemblies
(
).
g218652
Figure 4
1.
Roller shaft
8.
Flat washer
2.
Ball stud
9.
Bushing
3.
Ball-joint receiver
10.
Spacer
4.
Jam nut
11.
Pull-link assembly
5.
Long pull-link extension
12.
Link bracket
6.
Carriage bolt
13.
Bolt (3/8 x 2 inches)
7.
Locknut
14.
Anti-scalp roller
5.
Assemble the new longer pull-arm extensions to
the existing pull-link assemblies and ball-joint
receiver assemblies (
). Do not tighten
the jam nuts at this time.
6.
Mount the appropriate link bracket (left or right)
and a previously removed anti-scalp roller
to the end of each front carrier frame with a
new carriage bolt and roller shaft. Position the
brackets as shown in
7.
Mount a pull-link assembly to the outside of each
link bracket with a new bolt (3/8 x 2 inches),
previously removed flat washer, 2 new bushings,
a previously removed spacer, flat washer and
locknut. Position the components as shown in
Note:
Make sure that the bushings are inside
the pull-link assembly.
8.
Slide back the sleeve on the ball-joint receivers
and install the receivers onto the ball studs
(
).
9.
Mount a basket onto the carrier frame.
10.
Adjust the pull arms until there is a 2 to 3 mm
(1/16 to 1/8 inch) clearance between the lip of
the basket and the reel blades.
3
