Storage
Note:
Let the engine cool before storing it and do not store
it near a flame.
1.
Wash the brush housing and chopper with water. Turn
the key in the ignition switch to the O
N
position and
increase speed until the Chopper rotator is engaged.
Stand to 1 side at rear of machine and spray water into
spinning chopper until clean.
2.
Check all fasteners and tighten as necessary.
3.
Grease all grease fittings and wipe off excess lubricant.
4.
Check the condition of the brush and blades and
replace as required.
5.
Service the air cleaner; refer to
.
6.
Grease and oil the machine; refer to
Bearings and Bushings (page 34)
.
7.
Change the crankcase oil; refer to
.
8.
Check the tire pressure; refer to
.
9.
Charge the battery; refer to
Servicing the Battery (page
.
10.
Before disconnecting from the tow vehicle, lower the
core processor to the ground, install the storage pins
in the front holes, and then remove the hydraulic and
mechanical connections. This ensures that the core
processor remains stable when you disconnect it from
the tow vehicle.
45