Throttle Control (Fig. 7)—A lever connects to and
operates the throttle linkage to carburetor. The throt-
tle control has two positions: SLOW and FAST.
Engine speed can be varied between the two settings.
Note: The engine cannot be stopped by the throttle
control.
Hour Meter (Fig. 7)— Shows the total hours of
machine operation. The hour meter operates whenev-
er the key switch is turned to “ON”.
Ammeter (Fig. 7)—The ammeter indicates the rate
of battery charge or discharge.
Note: During normal operation, there will usually be
slight ammeter needle movement to positive side.
Lift Lever (Fig.7)—To raise the implement, pull the
lever up; to lower implement, push the lever down.
When the desired position is attained, release the
lever and it will return to neutral.
Note: The SAND PRO has a double-acting lift cylin-
der. Down pressure can be applied to the implement
for certain operating conditions.
Steering Wheel Tilt Lever (Fig. 8)—Lever on the
left side of steering column allows steering wheel to
be adjusted for operator comfort.
Seat Adjusting Lever (FIg.9)—Lever on the right
side of the seat allows the seat to be adjusted fore
and aft for operator comfort.
Fuel Shut-Off Valve (Fig. 10)—Close the fuel shut-
off valve when storing the machine.
13
Controls
Figure 8
1.
Steering wheel tilt lever
Figure 9
1.
Seat adjusting lever
➀
➀
Figure 10
1.
Fuel shut-off valve
➀
