Toro 07385TC Workman HDX-D, Original Instructions Manual

Page: 13 / 64

2
Installing the Rollover
Protection System (ROPS)
Parts needed for this procedure:
1 ROPS frame
6 Flange-head bolt (1/2 x 1-1/4 inches)
Procedure
1. Apply medium-grade (service-removable)
thread-locking compound to the threads of the 6
flange-head bolts (1/2 x 1-1/4 inches).
2. Align each side of the ROPS with the mounting
holes on each side of the machine frame (
Figure
4 ).
g009812
Figure 4
1. ROPS mounting bracket 2. Flange-head bolt (1/2 x
1-1/4 inches)
3. Secure the ROPS mounting bracket to the
machine frame using 3 flange-head bolts (1/2 x
1-1/4 inches) on each side (
Figure 4 ).
4. Torque the flange-head bolts (1/2 x 1-1/4 inches)
to 115 N∙m (85 ft-lb).
3
Checking the Fluid Levels
and Tire Pressure
No Parts Required
Procedure
1. Check the engine-oil level before and after
you first start the engine; refer to
Checking the
Engine-Oil Level (page 41) .
2. Check the transaxle/hydraulic-fluid level before
you first start the engine; refer to
Checking the
Transaxle/Hydraulic-Fluid Level (page 55) .
3. Check the brake-fluid level before you first start
the engine; refer to
Checking the Brake-Fluid
Level (page 51) .
4. Check the air pressure in the tires; refer to
Checking the Tire Pressure (page 20) .
4
Burnishing the Brakes
No Parts Required
Procedure
To ensure optimum performance of the brake system,
burnish (break-in) the brakes before use.
1. Bring the machine up to full speed, apply the
brakes to rapidly stop the machine without
locking up the tires.
2. Repeat this procedure 10 times, waiting 1 minute
between stops, to avoid overheating the brakes.
Important:
This procedure is most effective
if the machine is loaded with 454 kg (1,000
lb).
13