16
Installing the Seats
Insert the seat bracket into the seat base opening and pivot
the seat downward (Fig. 6).
1
2
Figure 6
1. Seat bracket
2. Seat base
Installing the Hitch
1.
Remove the 4 bolts and nuts from the inside rear of the
frame.
2.
Align the hitch with the mounting holes on the frame.
Secure the hitch with the screws and nuts (Fig. 7).
1
2
Figure 7
1. Hitch
2. Left pivot bracket
Installing the Batteries
Toro recommends the use of either Trojan T105 or T145, or
US. Battery US2200 or US145.
Battery Specification: 6V 225AH @ 20hr rate
Dimensions: (LxWxH) (10-1/4 x 7-1/8 x 11-1/4 inches)
1.
Turn the key switch to the Off position and remove the
key.
2.
Install the battery tray pads into the rear frame assembly
as shown Figure 8.
1
2
m–7647
Figure 8
1. Battery tray pads
2. Rear frame assembly
3.
Remove the adhesive strip from the back of the battery
pad and install it to the front inside face of the rear
frame as shown in Figure 9.
Note:
The pad should be approximately 1/4 inch below the
bottom edge of the upper set of cut-out holes (Fig. 9).
1
2
3
m–7646
Figure 9
1. Battery pad
2. Front inside face
3. Upper cut-out holes
4.
Install the batteries as shown in Figure 10.
Note:
Pay attention to the battery polarity when
installing the new batteries (Fig. 10).
