Toro 04260, Installation Instructions Manual

Page: 7 / 16

6. Insert the roller shaft into the right adjuster arm
and loosely secure it with a short bolt (
Figure
14 ).
g030181
Figure 14
1. Roller
2. Short bolt
7. Install the bushing in the hole in the left
groomer-drive assembly (
Figure 13 )
8. Thread the height-of-cut adjusting screw into the
top of the left adjuster-arm assembly (
Figure 13 ).
9. Insert the roller shaft into the left adjuster arm.
Note:
Do not tighten the bolt at this time.
10. Install the spring washer onto the rod end of the
left height-of-cut arm assembly (
Figure 13 )
11. Install the left adjuster-arm assembly to the
cutting unit side plate using a plow bolt, nut, and
new washer (
Figure 13 ).
Note:
Make sure that the rod end slides into
the bushing in the hole in the groomer drive
assembly.
12. Secure the adjuster-arm assembly rod end
to the groomer drive assembly with a locknut
(
Figure 13 ).
13. Fill the gearbox cover with approximately 0.15
L (5 oz) of Mobil XHP-221 or equivalent and
mount it to the groomer housing assembly with
the gasket in between using 5 bolts (
Figure 15 ).
G018184
1
2
3
g018184
Figure 15
1. Bolt 3. Gasket
2. Gear-box cover
14. Center the roller between the adjuster arms and
tighten the mounting bolts (
Figure 14 ).
15. If you are installing the kit on a TriFlex 3300 or
3400 machine , proceed to step 16 . If you are
installing the kit on a walk-behind unit , perform
the following steps:
A. Install the belt-drive assembly to the cutting
unit using the 3 bolts that you removed
previously (
Figure 6 ).
B. Install the pulley to the reel shaft using the
2 set screws that you removed previously
(
Figure 5 ).
C. Install the belt and tighten the belt-tensioning
nut (
Figure 4 ).
D. Install the belt cover and tighten the captive
bolt (
Figure 4 ).
16. If you are installing the kit on a TriFlex 3300 or
3400 machine , install the motor mount to the
left end of the cutting unit using the 2 bolts that
you removed previously (
Figure 3 ).
7