Toro 04260, Installation Instructions Manual

Page: 3 / 16

Installing the Groomer
Drive System
Preparing the Cutting Unit
Important:
Read these instructions thoroughly
before setting up or operating the groomer.
Failing to follow setup or operating instructions in
this manual may result in damage to the cutting
unit and/or the groomer or the turf.
Note:
Determine the left and right sides of the
machine from the normal operating position.
1. Separate the cutting unit from the traction unit.
Refer to the
Operator's Manual for procedure.
2. Loosen the screws securing each end of the
front roller to the height-of-cut arms (
Figure 1 ).
G019001
g019001
Figure 1
1. Height-of-cut arm
3. Plow bolt, washer, and
locknut
2. Roller-mounting screw 4. Adjusting screw
3. Remove the plow bolts, washers, and locknuts
securing the height-of-cut arms to each end of
cutting unit (
Figure 1 ). Remove the height-of-cut
arms and roller assembly.
Note:
Retain all parts for use if you ever remove
the groomer.
4. Remove the height-of-cut adjusting screws from
the height-of-cut arms (
Figure 1 ).
5. Remove the 2 bolts and nuts securing the
counterweight to the right end of the cutting unit.
Remove the counterweight (
Figure 2 ).
G016289
1
2
g016289
Figure 2
1. Counterweight 2. Bearing nut
6. Remove the bearing nut from the reel shaft
(
Figure 2 ).
7. If the kit is being installed on a TriFlex 3300,
3320, 3400, or 3420 machine, , remove the 2
bolts securing the motor mount to the left end
of the cutting unit. Remove the motor mount
(
Figure 3 ).
Note:
Retain the parts.
G016226
1
2
g016226
Figure 3
1. Bolt 2. Motor mount
3