Toro 03662, Installation Instructions Manual

Page: 3 / 8

2
Installing the Basket Guides
and Brackets
Parts needed for this procedure:
1 Basket guide
1 Basket bracket
1 Roll pin
1 Washer
1 Left-hand torsion-spring (gold)
1
Right-hand torsion-spring (black)
1 Basket collar
2 Flat washer (0.344 x 0.875)
1 Bolt (5/16 x 1–1/4 inch)
1 Bolt (5/16 x 1/2 inch)
1 Plastic washer
Procedure
1. Remove the cutting units from the cartons. Assemble
and adjust them according to the
Operator’s Manual for
the cutting unit.
2. Use Figure 2 to determine the locations where the
basket guides or basket brackets must be mounted to
the cutting-unit carrier-frames.
Figure 2
1. Center basket 5. Right, front basket
2. Left, rear basket 6. Basket guide
3. Right, rear basket 7. Basket bracket
4. Left, front basket
3. Mount a basket guide to the appropriate side of each
cutting unit carrier frame (
Figure 2 ) with a bolt (5/16 x
1/2 inch) and flat washer (0.344 x 0.875). Position the
components as shown in
Figure 3 .
Figure 3
1. Carrier frame 3. Flat washer (0.344 x
0.875)
2. Basket guide
4. Bolt (5/16 x 1/2 inch)
4. Install a roll pin into the lower hole in the appropriate
side of each cutting unit carrier frame (
Figure 4 ). The
end of the roll pin should be flush with the inner side
of the carrier frame.
Figure 4
1. Carrier frame 5. Torsion spring (left hand
shown)
2. Roll pin 6. Basket collar
3. Plastic washer 7. Flat washer (0.344 x
0.875)
4. Basket bracket 8. Bolt (5/16 x 1–1/4 inch)
5. On the same side of the carrier frame that the roll pin
is installed, mount a plastic washer, basket bracket,
torsion spring, basket collar, flat washer (0.344 x 0.875)
and bolt (5/16 x 1-1/4 inches) (
Figure 4 ).
Note:
The plastic washer, basket bracket, and torsion
spring fit onto the basket collar.
The gold torsion spring is for the left-hand side of the
carrier frame and the black spring is for the right-hand
side of the carrier frame. The longer leg of the spring is
to be positioned around the front of the carrier frame
3