Toro 02920, Installation Instructions Manual

Page: 3 / 12

WARNING
Incorrect battery cable routing could damage the
machine and cables, causing sparks. Sparks can
cause the battery gases to explode, resulting in
personal injury.
• Always disconnect the negative (black) battery
cable before disconnecting the positive (red)
cable.
• Always connect the positive (red) battery cable
before connecting the negative (black) cable.
1. Lift the cover of the negative battery cable ( Figure 5 ).
g188214
g037057
Figure 5
2. Remove the negative battery cable from the battery
(
Figure 5 ).
Note:
Position the negative battery cable where it
cannot contact the negative battery post.
3. Lift the cover of the positive battery cable.
Note:
Lifting the cover will loosen the battery cable
terminal from the positive battery post.
4. Remove the positive battery cable from the battery.
Removing the Bulkhead Panel
1. Remove the 4 bolts (6 x 25 mm), 4 lock washers
(6 mm), and 4 flat washers (6 mm) that secure the
bulkhead panel to the chassis of the machine (
Figure 6 ).
g037067
Figure 6
1. Bulkhead panel 3. Lock washer
2. Flat washer 4. Bolt
2. Move the panel up and forward, and remove it from
the machine (
Figure 6 ).
Installing the Kit
Installing the Brackets
Note:
You can install the beacon light on either side of the
ROPS frame.
1. Ensure that the ROPS pivot bolts and clamp bolts are
in place and tight.
2. On the same side of the ROPS on which you plan to
install the kit, remove the nut, bolt, and washer from
the ROPS and discard the nut and bolt; refer to
Figure
7 .
Note:
Retain the washer.
3