Form No. 3371-527 Rev B
Handlebar Extension Kit
HoverPro 450/500/550
Model No. 02623
Installation Instructions
Safety
The handlebar extension kit provides additional length to the
handlebars, allowing for easier mowing on slopes and similar
terrain.
•
Before using this kit, refer to the HoverPro
Operator’s
Manual
safety section.
•
Use care when maneuvering the machine. The longer
handle may make maneuvering more difficult.
•
Be careful when moving or storing the unit to prevent the
latching mechanism from breaking.
Vibration
Measured vibration level for the left hand = 7.7 m/s
2
(model
02602); 4.0 m/s
2
(model 02604); 6.8 m/s
2
(model 02606).
Measured vibration level for the right hand = 6.4 m/s
2
(model
02602); 5.3 m/s
2
(model 02604); 4.6 m/s
2
(model 02606).
Uncertainty Value (K) = 3.5 m/s
2
(model 02602); 2.5 m/s
2
(model 02604); 3.0 m/s
2
(model 02606).
The vibration levels of model 02602 was measured to
standard EN14910. The vibration levels of models 02604 and
02606 were measured to standard EN836.
Installation
1.
Remove the throttle control from the handlebar. Retain
the mounting fasteners (Figure 1). Loosen the throttle
control cable clamp on the engine, remove the outer
cable from the clamp, and remove the inner cable from
the lever (Figure 3).
2.
Remove the 2 handwheels and the 2 U-bolts to
disasemble the HoverPro's upper handlebar from the
lower handlebar. Retain the handwheels and U-bolts.
3.
Secure the handlebar extension to the lower handlebar
using 2 handwheels and 2 U-bolts (Figure 1).
g018541
1
2
3
4
5
Figure 1
1.
Throttle control assembly
(1)
4.
Handlebar extension (1)
2.
U-bolt (2)
5.
Cable tie (3)
3.
Handwheel (2)
© 2012—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Register at www.Toro.com.
Original Instructions (EN)
Printed in the UK.
All Rights Reserved
*3371-527* B
