3. OPERATING INSTRUCTIONS
T-OMPBM 12/2020
10
E. After use
1.
Upon completion of disinfection, empty contents of tank into an approved
storage container.
2.
Add ¼ gallon (half full) of clean water to the tank and replace cap.
3.
Turn unit ON, pull spray trigger, and allow clean water to flush through system,
making sure to follow proper disposal of the water being flushed through the
system as there will be residual chemical found in the spray (Follow chemical
manufacturer’s recommendation for disposal).
4.
Turn unit OFF, pull spray trigger again to relieve back pressure on unit.
5.
Remove battery.
6.
Empty contents of tank and store dry.
F. Troubleshooting
Issue
Possible Cause
Action
Wand Does Not
Spray
• Low battery voltage
• Battery not fully installed
• Clogged tip
• Low fluid level
Charge battery
Ensure battery fully installed.
Clean tip
Fill tank
Machine will not
turn on
• Low battery voltage
• Defective Switch
• Pump Failure
Charge battery
Call customer support
Call customer support
Low Solution Flow
• Clogged tip
• Not enough solution in tank
• Clogged tank filter
• Vacuum Lock
Clean tip
Fill tank
Clean in tank filter
See next page
Water Visible Under
Machine
• Loose plumbing connection
• Water spilled during filling
Call customer support
Dry unit and re-observe
Light not coming on
charger when
battery inserted
• Confirm charger plugged in
• Confirm power to plug
• Defective battery or charger
Plug in charger to 115V outlet
Flip breaker switch
Call customer support
Customer Support
If your system fails to function properly and is not addressed above, contact customer
support at 1-800-880-2913. User/freight damage will not be covered.
