7
GLAZER™ 1500 INSTRUCTIONS
GENERAL INFORMATION
Your Glazer™ 700/1500 is shipped with the handle
in an inverted position. See instruction sheet
enclosed in packet for assembly.
WARNINGS
1. Unplug machine when not in use. If handle
switch lever is activated accidentally high
starting torque will cause machine to move and
may cause damage or injury. Unplug machine
before:
z
Leaving machine unattended
z
Changing pads
z
Attempting any Maintenance or Adjustment
2.
Never operate this machine unless plug is
grounded - failure to ground could cause
electrical shock.
This appliance is equipped with a three-
conductor cable and three-prong grounding
type plug to fit a grounding type receptacle. Do
not break off or pull out the grounding prong on
plug. Adapters are available for connecting
three-prong grounding type plugs to two-prong
receptacles. The grounding wire or terminal
extending from the adapter must be connected
to a permanent ground such as to a properly
grounded electrical Outlet Box. If cord
becomes frayed or damaged in any manner,
replace. Otherwise possible electric shock may
result.
3. Do not put hands under base - rotating parts
could cause injury. Always keep hands, feet
and loose fitting clothing away from moving
parts to prevent possible injures. Use care to
keep electrical supply cable from contacting
moving parts.
4. To avoid electrical shock, use indoors only. Do
not use machine in areas where flammable
and/or explosive vapors or dust are present.
5. Make sure voltage and frequency at wall
receptacle correspond with that indicated on
nameplate before plugging in machine. 20 amp
circuit recommended. Right or left switch levers
will independently operate motor.
6. Never use a device to lock the switch lever in
the “ON” position.
7. Use only 12 ga. three-wire extension cable
which have 3-prong grounding type plugs and
3-prong receptacles that accept the machine’s
plug.
8. Always operate this machine with all of the
cable removed from the handle. Failure to do
so will upset the precision balance of the
machine.
Do not add weight to this machine - this also
will upset the balance and may cause motor to
overload.
9. If the pad holder needs to be replaced, be sure
to specify a genuine TORNADO holder when
ordering to assure precision balance of your
machine.
OPERATION AND MAINTENANCE
When starting machine, grasp handles tightly to
counter act the high starting torque. After initial
start, machine is easy to control. Do not lift up on
handle, hold steady on floor. Squeeze switch lever
to start; release to stop. A circuit breaker is located
on the lower left hand side of base. Should an
overload occur, attempt to locate the cause and
rest the breaker by pressing the black button.
POLISHING
Use 3/4” to 1” thick high speed burnishing pads.
Floors should be dry mopped to remove grit. Start
at point nearest electrical outlet and walk in a
straight line as far as cable will allow. Then turn
180º away from cable and machine in a path
parallel to, and slightly overlapping the first pass.
SPRAY BUFFING
Use 3/4” to 1” thick burnishing pad. The spray buff
solution should be applied to the floor ahead of the
machine. Do not run the machine into the spray or
mist of the spray buff solution. Use the same
straight line technique described in the Polishing
section.
https://harrissupplyind.com - To Order Parts Call 608-268-8080
