10
7. Securely insert the larger end of the flexible hose sleeve into the suction Intake
(refer to photo B).
8. Connect the extension wand onto the flexible hose.
9. Connect a floor tool onto the extension wand.
10. Check to make sure the On/Off switch is
in the "OFF" position.
NOTE: If your machine is supplied with a tank
drain hose, be sure the tank drain Ball Plug is
covering the hose opening before starting the
unit. The vacuum will not operate properly
with the Tank Drain Hose open (refer to
photo C).
OPERATION
AFTER SUCCESSFUL COMPLETION OF
THE SET UP PROCEDURES, YOUR
MACHINE IS NOW READY TO OPERATE.
PLEASE OBSERVE THE FOLLOWING
STEPS AND PRECAUTIONS AT ALL
TIMES:
1. While tightly grasping the flexible hose,
start the unit by turning the on On/Off switch
to the "ON" position.
2.
A.
WET PICKUP APPLICATIONS:
Using a floor tool move slowly across the
area you wish to clean. As the Canister of the
machine begins to fill, a float inside the filter
cage (refer to photo D) will rise and will close
the vacuum motor intake. Suction will stop.
At this point, turn the On/Off switch to the
"OFF" position and disconnect the power
cord from the receptacle.
Remove the Vac-Head and empty the
Canister as follows:
Unit Includes Tank Drain Hose:
Place the Tank Drain Hose in an area where
drainage will not be obstructed. Pull the tank
drain Ball Plug away from drain nozzle to
drain. Replace Ball Plug to close off drain
hose and attach drain hose back in its holding
bracket
.
Summary of Contents for 94220
Page 2: ...NOTES...
